CMD Slave (Cars, Trucks, Tractors and Marine)


The CMDFlash tool is a reader/programmer BDM,EOBD K-LINE,EOBD CAN-BUS,EOBD PWM for all the new generation ECUs.
With BDM you need to unplug the ECU from the vehicle, open and connect it to our tool using a connector available on every EDC16,Marelli,Siemens and Delphi ECU.
This Tool can be sold as a plug-in of our Map3d software or stand-alone.
The Software allow you to read/write the Eprom (29bl802 / M58), the internal firmware and the serial e2prom containing the car's codes.
Checksum correction algoritm is available for all the ECU families, this mean you don't have to care about checksums calculations .
With our tool is possible to read all the ecu's eprom, and after a bad map tuning, a system hung or an interrupted write operation
it is always possible to restart the program operation to restore the ECU and start the car.
All the ECU data can be stored in a single file with additional info like brand, model, plague, chassis number, data, note, customer .....
with search facilities and information directly integrated in microsoft windows explorer.


Features:

BDM Motorola Mpc
Bosch MED17 TRICORE BOOT
C16x / ST10 BOOT
CAN V2.0B 1Mb/s
K line ISO / KWP
J1850 PWM
Mitsubishi Lancer EVO 5->9
Industrial Vehicles 24V
Automatic resistor switch-KLine 470 ohm pull-up resistor for VAG EDC16
Protection dongle is now inside the black box
Old cars protocols ( i.e. EDC15, ME7, etc ) are now included
Master/Slave
Recovery mode
Automatic checksums

Update CMD BDM Plugin (Frame and probes not included)

 

New BOOT-MODE BOSCH MEDC17 IROM/XROM

Simos PCR2.1 VAG 1.6 TDi
DCM3.7 OBD Protocols released!






Bosch EDC17CP45 BMW BOOT-MODE with new Boot tuning protection
Bosch EDC17C41 BMW BOOT-MODE with new Boot tuning protection

BMW x35i MSD80 with tuning protection
BMW x44i MSD85 with tuning protection
Bosch EDC17C46 VAG BOOT-MODE

 

Contact us for info